Filter
Top Products
Motor
Baldor 2hp
Catalog
#VL3515T
12
2HP Super Dust Gorilla Owners Manual
O.A.S. 2007
c
XI. Wiring Diagram for Magnetic Starter (220v, 1 ** )*
*Starter will not operate at any other voltages.
**Starter is shown configured for 1O but can also be used for 2hp, 3O motors.
Always use a licensed, professional electrician.
Open access cover on the
Overload.
Set the overload amperage
dial for the SFA* amperage
of your motor. The SFA*
value can be found below:
SFA = 12.1
(FLA 11.5)
Note: Overload must be set
or nuisance tripping may
occur.
*SFA - Service Factor Amperage
*FLA - Full Load Amperage
I
O
Dedicated Receptacle Fed
from 2 Pole Dedicated Circuit
Breaker,
Magnetic Starter -
Mount Close to Collector
6 Long Type SJT
14 AWG Power Cord
6-20P
6-20R
Optional Remote Controller diagram pg. 19
* Note: Motor Starter supplied
with system is for 220v only.
Note: This Dust Collector is
pre-wired at the factory and
need only be plugged into a
NEMA 6020R dedicated
electrical receptacle. 3hp
single phase only.