Oregon 613GC Saw User Manual


 
613GC OPERATOR’S MANUAL
12
OPERATION
STARTING AND STOPPING A CHAIN-BASED CUT OFF SAW
Never start a chain-based cut off saw without the guide bar,
diamond chain and side cover properly assembled. The clutch may
come loose and cause personal injury.
Always move a chain-based cut off saw at least 10 feet (3 m) away
from the fueling area before starting.
Place the chain-based cut off saw on clear ground. Ensure that
secure footing is established and diamond chain is not contacting
any objects.
COLD ENGINE STARTING PROCEDURE
1. Toggle the ignition switch to the "ON" position and pull the
choke lever out.
2. Lock the throttle in the start position by depressing the trigger
(A) and trigger interlock (B) at the same time.
3. Depress and hold throttle lock button (C) while releasing the
trigger and trigger interlock in succession.
4. Press decompression valve (D).
5. Open the water valve ¼ turn.
6. Place the 613GC Cut-Off Saw on the ground making sure the
chain is free of any obstructions.
7. Place right foot on the base of the rear handle.
8. Place left hand on front handle.
9. With right hand, slowly pull starter handle until the starter
pawls engage.
10. Pull the starter cord (hard, fast, short pulls) until engine fires or
"pops" - should be 1 to 7 pulls.
11. Push the choke lever in.
12. Check decompression valve. Press if necessary.
13. Pull the starter cord until engine starts - should be 1 to 2 pulls.
14. When the engine starts, allow the engine to idle. Pull on the
throttle trigger several times to help warm up the engine.
15. Open the water valve completely.
Warm Engine Starting Procedure
1. Use the same procedure as starting cold engine, but DO NOT pull choke lever out. If choke is
used, the carburetor will flood with gas.
2. If the engine does not start in 3 hard, fast pulls with the throttle locked, unlock the throttle and pull
the starter cord 3 more times.
Note: To hold the trigger fully
open it may be necessary to insert right foot into rear handle opening
and twist.
CAUTION
WARNING
CAUTION
IMPORTANT
A
B
C
Figure 1: Trigger, trigger interlock,
throttle lock
Figure 2: Decompression valve
D