Filter
Top Products
613GC OPERATOR’S MANUAL
6
SAFETY
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided, may
result in minor or moderate injury or property damage.
• Always turn a chain-based cut off saw OFF when performing maintenance on the saw
including diamond chain tensioning.
• Never use equipment that is not functioning properly. Have the cut-off saw repaired by
qualified service personnel.
• Turn engine OFF before refueling. Keep away from open flame. Always provide adequate
ventilation when handling fuel. Move chain-based cut off saw at least 10 feet (3 m) away from
refueling area before starting.
• SealPro
®
diamond chains require a minimum water pressure of 20 psi (1.4 bar). Insufficient
water supply may result in excessive wear to the diamond chain, which can lead to loss of
strength and diamond chain breakage.
• Never start a chain-based cut off saw unless the guide bar, diamond
chain and side cover are properly installed.
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothes, including hard hat, eye protection, hearing protection, and gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on cut-off saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary people
present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is
dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.
CAUTION