Filter
Top Products
-
7
-
Attaching or removing battery
pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the bat-
tery pack out of the tool body.
. OPERATION
Switch Operation
1. The speed increases with the
amount of depression of the trigger.
When beginning work, depress the
trigger slightly to start the rotation
slowly.
2. A feedback electronic controller is
used to give a strong torque even in
low speed.
3. The brake operates when the trig-
ger is released and the motor stops
immediately.
Note: When the brake operates, a
braking sound may be heard.
This is normal.
Forward/Reverse lever Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION: Do not operate Forward/
Reverse lever until the
chuck comes to a com-
plete stop. Shifting during
rotation of the chuck may
damage the tool.
Forward Rotation Switch Operation
1. For forward rotation, set the lever to
forward.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the
amount of depression of the trigger
for efficient tightening of screws and
drilling. The brake operates and the
chuck stops immediately when the
trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch Operation
1. For reverse rotation, set the lever to
reverse. Check the direction of rota-
tion before use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 5 pos-
sible settings or “
“, “ “ position to
the job.
CAUTION: Test the setting before
actual operation.
Set the scale at this line.
Reference for Adjusting Torque
Scale
Torque Use
1
Approx. 1.0 Nm
(10 k
f-cm or 8.7 in-lbs.)
For driving terminal
screws
2
Approx. 1.5 Nm
(15 k
f-cm or 13.0 in-lbs.)
For driving machine
screws
3
Approx. 2.5 Nm
(25 k
f-cm or 21.7 in-lbs.)
For driving screws
into soft materials
4
Approx. 3.4 Nm
(35
k
f-cm
or
30.5
in-lbs.)
For driving screws
into hardwood
5
Approx. 4.4 Nm
(45
k
f-cm or 39.0 in-lbs.)
For powerful driving and drilling
Percussion
For drilling to mor-
tar, brick, etc.