Filter
Top Products
-
7
-
Attaching or removing battery
pack
1. To connect the battery pack:
Insert the battery pack. It snaps into
place to indicate proper connection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the battery
pack out of the tool body.
3. Support handle
Place the support handle at your
favorite position and tighten the han-
dle securely.
Loosen Tighten
Remove the handles when placing
the battery pack in the storage case.
. OPERATION
Switch Operation
1. The speed increases with the amount
of depression of the trigger. When
beginning work, depress the trigger
slightly to start the rotation slowly.
2. A feedback electronic controller is
used to give a strong torque even in
low speed.
3. The brake operates when the trigger
is released and the motor stops imme-
diately.
Note: When the brake operates, a
braking sound may be heard.
This is normal.
Forward/Reverse lever Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION: Do not operate Forward/
Reverse lever until the
chuck comes to a com-
plete stop. Shifting during
rotation of the chuck may
damage the tool.
Forward Rotation Switch Operation
1. For forward rotation, set the lever to
forward.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the amount
of depression of the trigger for efficient
tightening of screws and drilling. The
brake operates and the chuck stops
immediately when the trigger is re-
leased.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch Operation
1. For reverse rotation, set the lever to
reverse. Check the direction of rota-
tion before use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 15
possible settings or “ “ , “ “ position
to the job.
CAUTION: Test the setting before
actual operation.
Set the scale at this line.