Filter
Top Products
6 OnSite 3300 Quick Start Guide
Note PoE referenced in Figure 6 applies to Ethernet 0/3 only.
2.4 Connect the Power Source
The EFM Router does not have a power switch; it powers on once the device is plugged in.
The power connection is made via the barrel jack on the rear panel of the OS3300. No configuration is necessary
for the power supply.
2.5 Router/Bridge Status LEDs
The LEDs indicate the status of power, the WAN (OnSite) PoE, and Ethernet connections.
Note When powered down, the LED indicators are clear; when powered on, the LED indicators are yellow.
Figure 7. OS3300 front panel
Table 1. OS3300 front panel LEDs
LED Name LED Function Description
Power ON Indicates power is applied.
R
OFF
ON
WAN is configured as CO.
WAN is configured as CPE.
OnSite Pair
(one LED for each port [1
on OS3301, 2 on
OS3302, 4 on OS3304])
OFF
ON
SLOW BLINK
FAST BLINK
Port is configured as DOWN.
Port is in data mode.
Port is in handshake mode (looking for a CPE signal).
Port is in training mode (active communication with CPE).
PoE
OFF
ON
PoE is turned off.
PoE is turned on.
Ethernet
(0/0 - 0/3)
ON
OFF
Port is linked.
Data is passing over the port.