Filter
Top Products
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PRT-150
19
Operation
When making adjustments etc, always ensure the router is isolated
from the main electrical supply by switching off and removing the
plug from the socket.
Note: Always refer to the specific router operating instruction manual when
making height and speed adjustments etc.
Installing bits
To install bits whilst the router is situated in the table will require the router
to be lowered fully. Select desired bit and install. Fit the table insert closest to
the size of the bit, ensure the bit does not touch the insert.
Height adjustment
Raise the router until the bit protrudes through the table the required
amount. Make test cuts on scrap pieces of wood to set accurately.
Fence adjustment
Loosen the two fence clamping knobs and position the fence as desired, use
the graduation marks to set the fence parallel. Make test cuts on scrap pieces
of wood to set accurately.
Pressure pad
Set the fence pressure pad to hold the piece of wood flat on the table and
against the fence whilst machining. To do this, place the piece of wood
against the fence and below the relevant pad to be adjusted, loose the two
locking knobs and lower the pad until it rests on the wood, push the pad
down a little further to apply sufficient pressure to hold the wood flat on the
table. Adjust the table feather board in the same manner to hold the wood
firmly against the fence.
Jointing fence
Set the jointing fence to support the wood when cutting the full thickness.
Adjust the cutting depth etc as previously described, proceed to machine the
piece of wood until the lead edge passed over the jointing fence by approx
25mm. Switch off and isolate from the main electrical supply. Hold the wood
firmly against the Fence, loosen the jointing fence clamping knob, slide the
jointing fence out until it touches the wood and then tighten the clamping
knob. Back the workpiece away from the cutter before switching on again.
Helpline No. UK / Northern Ireland 0870 7323023 • Rep. Ireland 1800 481005
Web support: www.omegawolf.com/powercraft
Model Number: PRT-150
06
Machine specifications
1 Users manual
1 Quick set-up guide
1 After Sales-card