Filter
Top Products
14 © 2006 Pioneer Supply International
14 © 2006 Pioneer Supply International
Gearbox Oil Level
WARNING: Before starting your machine for the first time, make sure the gearbox has oil. The
proper oil level is just even with the bottom of the fill plug hole. The gearbox uses 80W-90W gear oil.
To check the gearbox oil level:
1 Remove the gearbox fill plug (Figure 11).
2 Using the short end of the hex wrench, dip it inside the fill hole and remove it. If the end of the hex wrench
is coated with oil, then the gearbox oil level is okay.
3 Replace the fill plug and skip to the next section. If the end of the hex wrench is not coated with oil, then
you need to add more oil. Refer to main-
tenance section of this manual for instructions on how add or drain oil.
NOTE: Replace the gearbox oil after the first 20 hours of operation. This is a normal break-in procedure.
Figure 9
Figure 10
Figure 11
Fill Plug
Drain
Safety Switch
NOTE:
The magnetic switch is there for your safety and
should not be replaced by a standard power switch. If the
power goes out, the magnetic switch prevents the machine
from starting when the power is returned, and protects the
operator from an accidental start and possible injury.
!