Porter-Cable 126 Planer User Manual


 
9
FUNCTIONAL DESCRIPTION
ASSEMBLY
CARTON CONTENTS
3) Replacement Parts List
4) Combination Package
OPERATION
A
D
B
C
Fig. 2
FOREWORD
Model 126 is a 7.0 amp, 22,000 RPM portable planer that can plane wood up to
2-13/32" wide and 3/32" deep.
NOTE: This tool is shipped completely assembled. No assembly time or tools
are required.
1. Turn the plane upside down on the bench so that it rests on the handle and
motor housing.
2. Remove the rear cover retaining screw (A) Fig. 1 on the cutter housing and
loosen the front screw (B), allowing the cover (C) to swing open.
3. When the cutter shaft (D) Fig. 1 is exposed, install the cutter (placing the
slotted end first) and then the spacer. Place the nut on the end of the shaft.
Insert a hex wrench in the end of the cutter shaft and hold it steady while
tightening the nut with the blade wrench (Fig. 2). Tighten the nut securely.
4. Put the cover back into place and tighten the cover retaining screws.
TO INSTALL THE CUTTER
DISCONNECT THE TOOL FROM THE POWER SOURCE!
1) Planer
2) Instruction Manual
Fig. 1