Filter
Top Products
NOTE: A slight twisting action will ease removal and reassembly.
Tap container lightly to remove compacted dust. DO NOT WASH
CONTAINER. Dry compressed air may be used to blow out container.
CAUTION: Wear safety glasses while using compressed air.
ACCESSORY PADS
Model 340 is supplied with a Standard Profile, PSA (Pressure Sensitive
Adhesive) Pad. This pad and some special purpose pads are available to fit
this machine. To install one of these accessory pads:
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Remove abrasive from sander.
3. Use a T20 Torx screwdriver to remove the four pad retaining screws (see
Fig. 13), and lift the foam pad (and its aluminum backing plate), off the
sander.
4. Position the accessory pad to the sander and attach with the four
screws from Step 3.
10
Fig. 12
B
A
Fig. 11
A
A
Fig. 11A
B
900008 - 04-29-02.qxd 5/23/02 2:17 PM Page 10