Filter
Top Products
7
Naturally, in all sanding operations, best results will be obtained if you select
the proper size and type of abrasives. Only garnet, aluminum oxide and
silicon carbide are recommended for use with finishing sanders.
Before starting to work, make sure you have the right abrasive for the
material on which the sander is to be used. Make sure you use the correct
size abrasive paper or cloth. Cut, do not tear, the abrasive sheets to size.
ATTACHING STIKIT™ ABRASIVE
STIKIT™ Abrasives are available in pre-cut sheets, or in rolls. A convenient
dispenser is also available for the rolls.
To install STIKIT™ abrasive, cut a 4
1
/4" long piece of abrasive from a roll (or
use a pre-cut sheet), align abrasive with sander pad and press in place as
shown in Fig. 1.
Punch holes in paper (for dust extraction), as instructed in PAPER PUNCH
section of this manual.
NOTE: DO NOT store Sander with an abrasive disc installed. Heat
generated by the sanding operation increases the adhesive bond
between the disc and pad. If disc is left on pad for an extended time after
use, it can become difficult to remove. If sanding disc is difficult to
remove, use the sander on a piece of scrap wood for one to two minutes
to warm the paper. This should make removal easier.
ATTACHING CONVENTIONAL ABRASIVE
1. CAUTION: DISCONNECT TOOL FROM POWER SOURCE.
2. Open paper clamp by lifting up on lever (A) Fig. 2 to release it from the
locking tab (B).
3. Position one 4
1/
2
" wide end, of a 4
1/
2
" x 5
1/
2
" piece of sandpaper, under
the open paper clamp (see Fig. 3), and hold, while lifting paper clamp lever
up and placing it behind the locking tab to secure the paper in place (see Fig.
4).
4. Open second paper clamp (as described in Step 2).
5. Stretch the sandpaper tight over the pad, position the loose end under
the second paper clamp, and close paper clamp.
6. Punch holes in paper (for dust extraction), as instructed in PAPER
PUNCH section of this manual.
Fig. 1
Fig. 2
B
A
900008 - 04-29-02.qxd 5/23/02 2:17 PM Page 7