Filter
Top Products
4
ASSEMBLY INSTRUCTIONS
ASSEMBLING BLADE
RAISING AND LOWERING
HANDWHEEL
1. Insert the 1-3/4" screw (D) Fig. 4, through handle
(E). Assemble handle (E) to handwheel (A) by threading
screw (D) clockwise into handwheel as shown in Fig. 5.
Handle (E) should rotate freely on screw (D).
Fig. 4
Fig. 5
ASSEMBLING BLADE
GUARD AND SPREADER
ASSEMBLY
1. WARNING: WHEN ASSEMBLING THE BLADE
GUARD AND SPREADER ASSEMBLY, MAKE
CERTAIN THE SAW IS DISCONNECTED FROM THE
POWER SOURCE.
2. IMPORTANT: THE BLADE GUARD AND SPREADER
ASSEMBLY MUST BE PROPERLY ALIGNED TO THE
SAW BLADE IN ORDER TO HELP PREVENT
KICKBACK.
3. Position the blade 90 degrees to the table and lock
in place.
4. Insert spreader end (A) Fig. 6, of blade guard into
anchor block (B). Push spreader (A) down into holder
until you hear a click, indicating that the spreader is
secured. NOTE: It is important that the spreader (A) be
in the vertical position and pushed straight down into the
spreader anchor block (B) during the assembly
procedure.
5. Fig. 7 illustrates the blade guard in place.
Fig. 6
Fig. 7
D
E
D
A
E
A
B