Filter
Top Products
16
SHAPING NARROW MATERIAL
When shaping narrow material (less than 3" wide) a support as shown in Fig.
27 must be clamped to your Router/Shaper and the workpiece fed under this
support with a push stick. The push stick should be slightly narrower and
thinner than the workpiece.
WARNING: Shaping narrow material without proper support and
push stick could result in serious injury.
MAINTENANCE
KEEPTOOLCLEAN
Periodically blow out all air passages with dry compressed air. Remove
buildup of grime resulting from working with green or sappy wood. All plastic
parts should be cleaned with a soft damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve or otherwise damage the material.
CAUTION: Wear safety glasses while using compressed air.
FAILURE TO STAR T
Should your tool fail to start, check to make sure the prongs on the cord plug
are making good contact in the outlet. Also, check for blown fuses or open
circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant
for the life of the unit under normal operating conditions. No further lubrication
is necessary.
Fig. 27
PUSH STICK SLIGHTLY
NARROW AND THINNER
THAN WORKPIECE
18"
WORK SUPPORT
WARNING: KEEP HANDS AWAY FROM CUTTER
WORKPIECE