Filter
Top Products
20
6. Verify that the bit is clear of foreign objects and that the cord will not get
caught on any obstructions.
7. Grasp the motor firmly to resist starting torque and move the switch button
to the "ON" position.
8. Allow the motor to reach full-speed. Feed the trimmer from right to left with
a smooth steady motion.
NOTE: The tapered edge of the underscribe base will slide underneath the rail
covering, lifting the laminate into the cutter.
9. After completing the cut, move the switch button to the "OFF" position
and allow the motor to come to a complete stop before putting the trimmer
down.
10. Press the rail end into position and roll down.
11. Repeat this process as necessary to complete the face frame.
MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts
should be cleaned with a soft damp cloth. NEVER use solvents to clean plastic
parts. They could possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are
making good contact in the outlet. Also, check for blown fuses or open circuit
breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for
the life of the unit under normal operating conditions. No further lubrication is
necessary.
BRUSH INSPECTION (If applicable)
For your continued safety and electrical protection, brush inspection and
replacement on this tool should ONLY be performed by an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE
•DELTA
FACTORY SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest
authorized Porter-Cable Service Station to be thoroughly cleaned and inspected.
Have worn parts replaced and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance check may indicate the need
for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. If proper operating voltage is present, return your
tool to the service station for immediate service.
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers, or call the Porter-Cable Customer Care Center at 1-800-
223-7278.
TROUBLESHOOTING