Filter
Top Products
12
CONNECTING TO POWER SOURCE
Confirm that the switch is “OFF” and the power circuit
voltage is the same as the voltage shown on the
specification plate. Connect the machine to a power circuit.
STARTING AND STOPPING THE MOTOR
Before starting the router, make sure bit is clear of
workpiece and foreign objects. Also keep a firm grip on the
router to resist starting torque.
1. Squeeze the trigger switch (A) Fig.
9 to start the motor. Release the
trigger switch to stop the motor.
2. To allow the motor to run
continuously, press the trigger
switch (A), push the lock button (B)
Fig. 9, and release the trigger
switch.
3. To release the lock button, squeeze
the trigger switch and release.
OPERATION
ADJUSTING PLUNGE LOCKING LEVER
You can adjust the plunge locking mechanism to compensate for wear or to
reposition lever (in locked position). To adjust:
1. Hold the lever in the upright position (see Fig. 7). Use a phillips
screwdriver to remove retaining screw (V) Fig. 7. Continue to hold the
lever through the remaining steps.
2. Insert a 1/8" hex wrench (not furnished) into the adjusting screw (see
Fig. 8) and turn counter-clockwise approximately 1/2 turn.
3. Move the lever to the desired position and tighten the adjusting screw.
4. Remove the hex wrench and replace the retaining screw.
DISCONNECT TOOL FROM POWER SOURCE.
V
B
A
Fig. 7
Fig. 8
Fig. 9