Filter
Top Products
15
TO ADJUST DEPTH OF CUT
Adjust the depth of cut so that the saw blade just protrudes through the
thickness of workpiece being cut.
To adjust the depth of cut:
Remove the battery pack.
1. Lift up the depth adjusting lever (H) Fig. 9 at the rear of the saw.
2. Raise or lower the saw housing until the blade extends the desired
distance below the workpiece.
NOTE: The depth adjusting segment (J) Fig. 10 is marked in 1/8"
increments. Aligning the required marking with the lower edge of the
housing will produce the approximate depth of cut desired.
3. Press the depth adjusting locking lever down firmly, locking the saw in
the selected position.
TO ADJUST FOR BEVEL CUTS
Remove the battery pack.
1. Lift up the bevel adjustment
locking lever (K) Fig. 11.
2. Tilt the saw base until the
desired graduation line on the
bevel segment (L) Fig. 11 lines
up with the indicating mark (M)
Fig. 11 on bracket.
3. Return the bevel adjustment
locking lever to the locked
position and press down firmIy.
Fig. 7
Fig. 8
G
E
F
Fig. 9 Fig. 10
H
J
Fig. 11
K
M
L