Filter
Top Products
18
2. Insert the nozzle in the exhaust
opening and push in until seated.
3. To remove, grasp the nozzle and
pull out.
Never direct sawdust
toward anyone. To avoid personal
injury from flying sawdust, keep the
exhaust cover closed when the
nozzle is not attached. NEVER insert
foreign objects into the exhaust
opening.
INSTALLATION AND CARE OF DUST BAG
Remove the battery pack.
1. Swing open the exhaust cover
(U) Fig. 19 and clean out any
accumulated sawdust.
2. Insert the dust bag in the
exhaust opening and push until
seated.
3. To remove, grasp the dust bag
tube and pull out.
4. Unzip the bag and shake out the
sawdust. Occasionally turn the
bag inside out and brush out
thoroughly.
VACUUM CLEANER ADAPTER
An adapter/hose assembly is available as an accessory for connecting the
exhaust opening directly to a shop-type vacuum cleaner.
TO ATTACH RIP GUIDE
A rip guide (V) Fig. 20 is available as an accessory. To install:
Remove the battery pack.
1. Insert the rip guide (V) Fig. 20
through the slot in the left side of
the base, over the stud, and
through the slot in the right side
of the base.
2. Install the washer and knob (W)
Fig. 20 on the stud (do not
tighten) and adjust rip guide for
desired width of cut.
3. Tighten the knob securely.
To avoid damage to workpiece and possible personal
injury, always extend the rip guide through both slots in base.
Fig. 18
U
Fig. 19
U
Fig. 20
V
W