Filter
Top Products
12
CLEARING A JAMMED FASTENER
1. WARNING: Disconnect tool from air supply and/or remove battery.
2. Open magazine and remove any remaining fasteners (see Fig. 16).
CAUTION: Remove fasteners from tool before opening the fastener
guide plate. Fasteners are under pressure and may shoot out of
magazine which could cause injury.
3. Depress the quick release latch (A) Fig. 20 and open the fastener guide
plate (B) Fig. 20.
4. Remove the jammed fastener (A) Fig. 21.
5. Depress the quick release latch
(A) Fig. 20, close the fastener guide
plate (B), and release the latch (A).
NOSE CUSHION
This tool is equipped with a rubber
nose cushion (A) Fig. 22, that prevents
marring of finished surfaces by the
metal safety during normal operation.
The nose cushion can be removed
and stored in the rear area of the
magazine (B) Fig. 22, when it is not
required.
WARNING: Disconnect tool from air supply and/or remove battery
before removing or reinstalling rubber nose cushion.
Fig. 20
Fig. 21
Fig. 22
A
B
A
A
B
• HIGH
• NORMAL
• OFF
• EXT AIR
901891 - 08-31-01.qxd 2/13/02 11:53 AM Page 12