Filter
Top Products
3
9. THE TOOL COMES EQUIPPED WITH
TWIN POWER SOURCE TECHNOLOGY
(TPS)
™
. DISCONNECT TOOL FROM AIR
SUPPLY HOSE AND/OR REMOVE
BATTERY before doing tool maintenance,
clearing a jammed fastener, leaving work
area, moving tool to another location,
handing the tool to another person, or
making adjustments. Fig. 4.
10. NEVER USE A TOOL that is leaking
air, has missing or damaged parts, or
requires repair. Make sure all screws and
caps are securely tightened.
11. NEVER USE TOOL IF SAFETY, trigger
or springs are inoperable, missing or
damaged. Do not alter or remove safety,
trigger, or springs. Make daily inspections
for free movement of trigger and safety
mechanism. Fig. 5.
12. DO NOT USE TOOL WITHOUT
SAFETY WARNING LABEL. If label is
missing, damaged or unreadable, contact
your Porter-Cable Service Center for a
replacement. Fig. 6.
13. ONLY USE PARTS, FASTENERS,
AND ACCESSORIES recommended by
Porter-Cable.
14. REMOVE ALL FASTENERS from tool
before connecting to battery and/or air
supply. The tool’s driving mechanism may
cycle when tool is connected to the power
source. Fig. 7.
15. ALWAYS ASSUME THE TOOL
CONTAINS FASTENERS. Keep the tool
pointed away from yourself and others at all
times. No horseplay. Respect the tool as a
working implement. Fig. 8.
16. DO NOT LOAD FASTENERS with
trigger or safety depressed, to prevent
unintentional firing of a fastener. Fig. 9.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
1
2
WARNING
1. Read and understand tool labels and manual.
Failure to follow warnings could result in DEATH
or SERIOUS INJURY.
2. Operators and others in work area MUST wear
safety glasses with side shields.
3. Keep fingers AWAY from trigger when not
driving fasteners to avoid accidental firing.
4. Choice of triggering method is important. Check
manual for triggering options.
5. Remove battery, fasteners, and external air
supply before servicing tool.
6. NEVER point tool at yourself or others in work
area.
7. NEVER use oxygen or other bottled gases.
Explosion may occur.
901891 - 08-31-01.qxd 2/13/02 11:51 AM Page 3