Filter
Top Products
MAINTENANCE
CLEAN AND INSPECT DAILY
WARNING: Disconnect tool from air supply and/or remove battery
before cleaning and inspection. Correct all problems before placing
the tool back in use.
Wipe tool clean and inspect for wear or damage. Use non-flammable
cleaning solutions to wipe exterior of tool only if necessary. DO NOT SOAK
tool with cleaning solutions. Such solutions can damage internal parts.
Inspect trigger and safety mechanism to assure system is complete and
functional: no loose or missing parts, no binding or sticking parts.
Keep all screws tight. Loose screws can cause personal injury or damage
tool.
If tool is used without an in-line oiler: place 5 - 6 drops of Porter-Cable Air
Tool Oil into the air inlet of the tool at the beginning of each workday.
REPLACEMENT PARTS
When servicing use only identical replacement parts.
FAILURE TO START
Should your tool fail to start, make sure battery pack is charged and properly
installed.
BATTERY
The battery pack will discharge by itself without damage if stored for long
periods of time, and may require recharging before use.
SERVICE AND REPAIRS
All quality tools eventually require servicing or replacement of parts due to
wear from normal use. Some user serviceable components are described in
the TROUBLESHOOTING Section. Complete product Service is available
from either an AUTHORIZED PORTER-CABLE SERVICE STATION or a
PORTER-CABLE/DELTA FACTORY SERVICE CENTER. All repairs made by
these agencies are fully guaranteed against defective material and
workmanship. We cannot guarantee repairs made or attempted by anyone
other than these agencies.
Should you have any questions about your tool, feel free to write us at any
time. In any communications, please give all information shown on the
nameplate of your tool (model number, type, serial number, etc.).
15
901891 - 08-31-01.qxd 2/13/02 11:53 AM Page 15