Filter
Top Products
22 - ENG
PROBLEM CAUSE CORRECTION
KnockingNoise Possible defect in
safety valve.
Operate safety valve manually
by pulling on ring. If valve still
leaks, it should be replaced.
Defective check valve. Remove and clean, or replace.
Loose pulley. Tighten pulley set screw.
Loose flywheel. Tighten flywheel screw.
Compressor mounting
screws loose.
Tighten mounting screws.
Loose belt. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Carbon build-
up in pump.
Have checked by a Trained
Service Technician.
Belt too tight. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Excessive
belt wear
Loose belt. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Tight belt. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Loose pulley. Have checked by a Trained
Service Technician.
Pulley misalignment.
See Motor Pulley/Flywheel
Alignment paragraph in the
Maintenance section.
Squealing
sound
Compressor pump
has no oil.
See Oil-Checking paragraph
in the Maintenance section.
Loose belt. Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.