Filter
Top Products
9-ENG
D26998
2. Position one handle and grip assembly into clamp on left side of tank
assembly, as shown in Figure. Align hole in handle with hole in clamp. Insert
bolt (N) through the hole (in clamp and handle). Thread nut (O) onto bolt.
Using two 1/2" wrenches (not furnished) tighten nut securely.
3. Repeat step 2 to assemble remaining handle and grip assembly to the
clamp on the right side of tank assembly.
4. Using a 9/16" socket wrench (not furnished) remove the four bolts securing
the compressor to the shipping skid.
A. Place spacer (S) on flat side of a rubber foot (R). Place spacer and rub-
ber foot against compressor frame as shown in Figure.
B. Align hole in spacer and rubber foot with one of the smaller holes adja-
cent to the holes where shipping skid was attached.
C. Insert one of the 1/4"-20 x 3/4" bolts (P), from the hardware package,
and using a 3/8" socket wrench (not furnished) tighten firmly.
D. Repeat A through C to install the three remaining rubber feet.
Lubrication and Oil
Engine
Drain tank to release air pressure before removing the oil
fill cap or oil drain plug.
1. The engine was filled WITH
oil at the manufacturer. Check engine oil level
before operating unit. If necessary, fill engine to the appropriate level with
recommended oil, see engine manual supplied by engine manufacturer for
correct procedure.
2. Add fuel to engine. See engine manual supplied by engine manufacturer for
correct procedure.
Gasoline vapor is highly flammable. Refuel outdoors
preferably, or only in well-ventilated areas. Do not refuel or
check gasoline level while the engine is running. Do not store, spill, or use
gasoline near an open flame, a source of sparks (such as welding), or near
operating electrical equipment.
Air Compressor
The air compressor pump was filled WITH
oil at the manufacturer. Check air
compressor pump oil level before operating unit. If necessary, fill pump to the
appropriate level with approved compressor oil, see the Maintenance section of
this manual for details.