11
CABLE/DELTA FACTORY SERVICE CENTER. All repairs made by these
agencies are fully guaranteed against defective material and workmanship.
We cannot guarantee repairs made or attempted by anyone other than these
agencies.
Should you have any questions about your tool, feel free to write us at any
time. In any communications, please give your tool model and serial number.
TROUBLESHOOTING
WARNING: Disconnect tool from air supply before performing any
Service Procedure.
SYMPTOM PROBLEMS SOLUTIONS
1. Air leak near top of Loose screws. Tighten cap screws
tool. Worn or damaged Install Overhaul Kit.
o-rings or seals.
2. Tool Leaks air or will Internal valve has If the tool is dropped after the air
not function shifted. pressure is removed from the tool,
the internal valve mechanism may
shift into the open position. When
connected to the compressed air
source, the tool will not operate due
to an air leak. To reset the internal
valve to the closed position,
disconnect the air supply and
sharply impact the tool cap against a
piece of wood. Connect the air
supply hose: The air pressure will
seat the valve in the close position.
3. Tool does nothing or Inadequate air supply. Verify adequate air supply.
operates sluggishly. Inadequate lubrication. Put 5 or 6 drops of oil into air inlet.
Worn or damaged Install Overhaul Kit.
o-rings or seals.
4. Air leak near bottom Loose screws. Tighten cap screws
of tool. Worn or damaged Install Overhaul Kit.
o-rings or bumper.
5. Other. Contact a Porter-Cable
Service Facility.
ACCESSORIES
A complete line of accessories is available from your Porter-Cable •
Delta Supplier, Porter-Cable • Delta Factory Service Centers, and
Porter-Cable Authorized Service Stations. Please visit our Web Site
www.porter-cable.com for a catalog or for the name of your nearest
supplier.
WARNING: Since accessories other than those offered by Porter-
Cable •
Delta have not been tested with this product, use of such
accessories could be hazardous. For
safest operation, only Porter-
Cable • Delta recommended accessories should be used with this
product.