Filter
Top Products
5
EMPLOYER’S RESPONSIBILITIES
DANGER: Employer must enforce compliance with the safety warnings
and all other instructions contained in this manual.
Keep this manual available for use by all people assigned to use this tool.
For personal safety and proper operation of this tool, read and understand
tool labels and manual. Failure to follow warnings could result in DEATH or
SERIOUS INJURY. Read and follow all of these instructions carefully.
FUNCTIONAL DESCRIPTION
FOREWORD
Porter-Cable Model PN650 is a heavy duty pneumatic palm nailer. The tool,
as supplied, is assembled with the magnetic nail guide for driving 6d to 16d
common flat head nails. Other guides included in the kit are the finish nail
guide (C) Fig. 13 for 1-
1
/
4
"(3d) to 2-
1
/2"(8d) finish nails, standard guide (I) and
bushing (H) for 4" (20d) to 6-
1
/2" (70d) common nails/spikes. A hammer head
attachment (D-G) is also supplied, which is capable of various other driving
tasks not suitable for the other three guides.
POWER SOURCE
This tool is designed to operate on clean, dry, compressed air at regulated
pressures between 50 and 120 PSI (Pounds per Square Inch)
(3.4 to 8.3 BAR)
.
The preferred system would include a filter, a pressure regulator, and an
automatic oiler located as close to the tool as possible (within 15 ft/4.6 m is
ideal).
All compressed air contains moisture and other contaminates that are
detrimental to internal components of the tool. An air line filter will remove
most of these contaminates and significantly prolong the life of the tool. If an
in-line oiler is not available: place five or six drops of Porter-Cable Air Tool Oil
into the tool’s air inlet at the beginning of each workday.
The tool is equipped with a
1
/
4" male “quick connector”. The tool must always
be connected to the air supply with a coupling such that all pressure is
removed from the tool when the coupling is disconnected.
Fig. 13
B
A
C
J
I
H
G
D
F
E
A- Palm Nailer
B- Glove
C- Finish Nail Guide
D- Hammer Base
E- Hammer Head
F- Hammer Guide
Bushing
G- Hammer Sleeve
H- Standard Guide
Bushing
I- Standard Guide
J- Open End Wrench
24mm x 30mm