Filter
Top Products
7
FINISH NAIL GUIDE ASSEMBLY
1. WARNING: Disconnect tool from air supply.
2. The finish nail guide (A) Fig. 17, for driving 1-
1
/
4
"(3d) to 2-
1
/2"(8d) finish
nails, is provided with a rubber nose cushion (B) Fig. 17 that will reduce
marring of the work surface. Assembly of the finish nail guide requires the
use of the magnetic nail guide bushing supplied on the tool (Fig. 15).
3 To install finish nail guide, lay tool on its cap with nail guide pointing
upward. Loosen and remove the magnetic nail guide bushing (B) Fig. 15
using the 24mm open end wrench supplied.
4. Lift the magnetic nail guide (A) Fig. 15 off of the driver blade and place it in
the carrying case.
5. Remove the plastic plug (C) Fig. 17 from the finish nail guide. Take care
not to allow the drive pin and spring to fall out of the bore of the finish nail
guide. Slide the finish nail guide (A) Fig. 18 over the driver blade.
6. Slide the magnetic nail guide bushing (B) Fig. 18 over the finish nail guide
and screw it into the housing using the 24mm open end wrench and tighten
as securely as possible.
STANDARD NAIL GUIDE ASSEMBLY
1. WARNING: Disconnect tool from air supply.
2. Standard (spike) nail guide has a ¾" ID and is used for driving large 4"
(20d) to 6-
1
/2" (70d) common nails/spikes.
3. To install standard (spike) nail guide and bushing, lay tool on its cap with
nail guide pointing upward. Loosen and remove the magnetic nail guide
bushing (B) Fig. 15 using the 24mm open end wrench supplied.
4. Slide the magnetic nail guide (A) Fig. 15 off of the driver blade.
5. Place both the magnetic nail guide and bushing in the carrying case for
safe storage.
6. Take the standard nail guide (A) Fig. 19 and guide bushing (B) from the
carrying case.
7. Slide the standard nail guide (A) Fig. 20 over the driver blade and inside of
the spring coils. Slide the standard nail guide bushing (B) over the driver
blade and spring. Screw the standard nail guide bushing into the tool
housing and tighten as securely as possible using the 24mm open end
wrench.
Fig. 17
A
B
C
Fig. 18
A
B