Filter
Top Products
4
9. Use clean, dry, regulated, compressed
air at 50 to 120 PSI, (3.4 to 8.3 BAR). Fig. 6.
10. Connect tool to air supply hose with a
coupling that automatically removes all
pressure from the tool when the coupling is
disconnected. Fig. 7.
11. Disconnect tool from air supply hose
before doing tool maintenance, clearing a
jammed fastener, leaving work area, moving
tool to another location, or handing the tool to
another person. Fig. 7.
12. Never use a tool that is leaking air, has
missing or damaged parts, or requires repair.
Make sure all screws and caps are securely
tightened. Fig. 8.
13. Do not overreach. Keep proper footing
and balance at all times when using or
handling the tool. Fig. 9
14. Fire fasteners into work surface only:
never into materials too hard to penetrate. Fig.
10.
15. Grip tool firmly to maintain control.
16 Do not drive fasteners on top of other
fasteners, or with the tool at too steep an
angle: the fasteners can ricochet causing
personal injury. Fig. 10.
17. Do not drive fasteners close to the edge
of the workpiece. The workpiece is likely to
split allowing the fastener to fly free or ricochet
causing personal injury. Fig. 10.
18. Operator and bystanders wear hard hat
to safeguard against possible injuries. Fig. 11.
Fig. 8
Fig. 9
Fig. 6
Fig. 11
Fig. 7
Fig. 10