Filter
Top Products
29
ELECTRICAL: Remote ON/OFF Switch (Optional)
NOTE:
The lathe can only operate when both the
headstock and remote switches are in the
"ON" position.
STEP 1:
Disconnect all electrical power to lathe.
STEP 2:
Remove the two screws from the control panel.
Do NOT disconnect control panel from wiring harness.
STEP 3:
Run the remote switch's wiring harness through the opening in the back of the headstock and out through
the front of the headstock.
STEP 4:
Connect the remote switch wiring harness to the back of the Push/Pull switch
(Refer to the electrical schematic on page 29).
STEP 5:
Reinstall the control panel to the headstock.
From the back of the headstock, lightly pull out any excess wire that may be inside the headstock.
STEP 6:
The magnetic back on the remote switch will allow the switch to be placed anywhere on the lathe.
STEP 7:
Connect electrical power to the lathe and resume operation.