Filter
Top Products
12
Installing Fence Handwheel
Refer to Figure 12.
Install the handwheel (H) onto the shaft, and
tighten the set screw with a 3mm hex wrench.
Knife Gauge Assembly (model 60C only)
Refer to Figure 13.
The knife gauge assembly consists of a bar, two
end pieces and two e-clips. Slide the end pieces
onto the ends of the bar as shown, and use a
pliers to push the e-clips into the grooves on the
bar.
Storing the Push Blocks
The two provided push blocks have a magnetic
base – you can attach them to the jointer stand
or any metallic surface, to keep them within
easy reach.
Electrical Connections
Electrical connections must
be made by a qualified electrician in
compliance with all relevant codes. This
machine must be properly grounded to help
prevent electrical shock and possible fatal
injury.
The Jointer is equipped with either a single
phase, 230 volt motor; or a three phase,
230/460 volt motor.
The single phase unit is factory wired for 230
volts. The jointer has a ground plug that looks
like the plug illustrated in Figure 14. Or, you may
“hard-wire” the jointer directly to a service panel.
It is recommended that the single phase jointer
be connected to a dedicated, minimum 20 amp
circuit with a 20 amp circuit breaker or time
delay fuse. Local codes take precedence over
recommendations.
The three phase motor is pre-wired for 230 volt.
It may be re-connected for 460 volts by
changing the connections as illustrated in the
diagram in the starter box (see “Converting from
230 Volt to 460 Volt”). “Hard-wire” the machine
directly to a control panel, and make sure a
disconnect is available for the operator.
It is recommended that the three phase jointer,
when operated at 230 volts, be connected to a
dedicated, minimum 20 amp circuit with a 20
amp circuit breaker or time delay fuse. When
operated at 460 volts, connect the jointer to a
dedicated, minimum 15 amp circuit with 15 amp
circuit breaker or time delay fuse. Local codes
take precedence over recommendations.
Figure 12
Figure 13
(model 60C only)
Figure 14