Filter
Top Products
5
SAFETY: Decal Instruction
CAREFULLY READ INSTRUCTION MANUAL
BEFORE OPERATING MACHINE.
DO NOT OPERATE WITHOUT ALL GUARDS AND
COVERS IN POSITION.
BE SURE MACHINE IS ELECTRICALLY GROUNDED.
REMOVE OR FASTEN LOOSE ARTICLES OF CLOTHING
SUCH AS NECKTIES, ETC. CONFINE HAIR.
USE SAFETY FACE SHIELD, GOGGLES, OR GLASSES
TO PROTECT EYES AND OTHER PERSONAL SAFETY
EQUIPMENT AS REQUIRED.
STOP MACHINE BEFORE MAKING ADJUSTMENTS OR
CLEANING CHIPS FROM WORK AREA.
KEEP THE FLOOR AROUND THE MACHINE CLEAN AND
FREE FROM SCRAPS, SAWDUST, OIL OR GREASE TO
MINIMIZE THE DANGER OF SLIPPING.
SPECIFICATIONS (6108 Edge Sander)
Sanding belt size ............................................................. 6" x 108"
Front table ...................................................................37" x 7-3/4"
Side table ........................................................................ 19" x 12"
Dust chute ........................................................................... 4" dia.
Belt speed ................................................................. 3,150 SFPM
Overall dimensions ......................... 64-1/2" L x 23" W x 43-1/4" H
Motor .......................... 1-1/2 HP, 1 Ph, 115/230V (prewired 115V)
2 HP, 3 Ph, 230/460V (prewired 230V)
Drive wheel ................................................................. 7" O.D. x 6"
Net weight ........................................................................ 491 lbs.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals, work in a well-
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cifically designed to filter out microscopic particles.
SAFETY: Specific Rules
1. Before you turn on the machine, make sure
everyone is clear of it. Keep hands away from
abrasive belt.
2. Never remove safety guards during operation.
3. Make sure the abrasive belt is not torn or
loose.
4. Make sure the direction of rotation is the same
as that marked on the machine label. If not, the
power connection must be changed.
5. Make sure the abrasive belt is tracking prop-
erly.
6. Support your workpiece with the work table.
7. When front work table is to be used at an in-
cline, check that the work table is firmly fixed on
the machine.
8. Sand with the grain of the wood.
9. Hold the workpiece firmly, to prevent it being
driven from your hands.
10. Feed workpiece against rotation of abrasive
belt.
11. Do not put excess pressure on the abrasive
belt. It is not necessary and will only lead to dam-
age to the belt or the workpiece.