Filter
Top Products
9
MAINTENANCE
LUBRICATION
CAUTION: Disconnect sander from power
source before performing maintenance.
Do not operate the sander until it is properly lubri-
cated.
All ball bearings are sealed for life and do not require
lubrication.
Apply a drop of light machine oil occasionally on the
hinge of the tension mechanisms as shown in Fig-
ure 10. Service the machine every 6 weeks.
SANDING BELT SELECTION
Use the chart, Figure 11, for selecting an abrasive
belt. Aluminum oxide is recommended for general
use in the home workshop.
Figure 12 groups abrasives into five classes, indi-
cating the grit numbers that fall into each.
FIGURE 11
EVISARBAESUESRAOC
TIRG
MUIDEM
ENIF
munimulAdoowdraH04-0308-06021-001
edixOmunimulA0408-06001
reppoC05-04001-08021-001
leetS03-4208-06001
yrovI08-06021-001082-021
citsalP08-05081-021042
FIGURE 12
EPYTENIFYREVENIFMUIDEMESRAOC
YREV
ESRAOC
edixOmunimulA063-022081-021001-0806-0463-42
FIGURE 10