Powermatic 75 Dust Collector User Manual


 
10
4. Turn the base upright on to its casters. Attach
the two support brackets to the threaded holes in the
center of the base, as shown in Figure 6. Use four
screws with four flat washers. NOTE: Be careful not
to strip the screws.
5. With the aid of an assistant, lift the impeller hous-
ing with motor on to the support brackets, dropping
the four bolts mounted to the impeller housing into the
four holes in the support brackets. See Figure 7.
Secure with four nuts, four lock washers, and four flat
washers.
NOTE: Minor adjustments can be made by slightly
loosening the screws at the bottom of the support
brackets and moving the brackets accordingly. Be sure
to re-tighten the screws after adjusting.
6. Mount the two side housings onto the impeller
housing, making sure they are oriented properly, as
shown in Figure 8. Place a rubber gasket over the
opening of the housing, inserting the small knobs on
the gasket into the corner holes of the housing open-
ing.
Attach the housings, each with eight screws, sixteen
flat washers, and eight nuts. Tighten all screws and
nuts.
FIGURE 6
FIGURE 7
FIGURE 8