Filter
Top Products
22
Maintenance
The sliding table should be cleaned once a
week, and all sawdust and chips removed.
From both sides of the sliding table, blow out
the dust which has accumulated between the
two sections and on the ball carrier. This can be
done more efficiently when the upper part of the
sliding table is slid to the rear. Then repeat the
process when the upper part is slid to the front
end.
Remove any resin deposits on sliding table and
other surfaces.
After blowing out the dust, spray a thin oil onto
the steel rods (Figure 40) on both the upper and
lower part of the sliding table. Never use a thick
oil or grease!
Lubricate all moving parts with a light coating of
oil.
NOTE: All bearings in the machine are self-
sealed and require no lubrication.
Blow sawdust out of the cooling fan and motor.
Figure 40