Filter
Top Products
15
101274
5. Place the muzzle of tool perpendicular to work surface
without tilting the tool. Push tool against work surface until
sliding action of barrel stops.
6. Squeeze trigger to set power fastener. Be sure to keep
pressure on tool during this operation.
7. After fastening is made, slide barrel forward rapidly. This
motion ejects the spent powder load and resets the piston
for the next fastening. Make sure spent load has ejected
from tool.
8. Should the tool fail to fire, hold the muzzle firmly against
the work surface for 30 seconds. Release the trigger and
remove pressure on the tool while holding the muzzle
against the work surface. Again press the tool firmly
against the work surface and pull the trigger. If the tool still
fails to fire, hold the tool firmly against the work surface for
another 30 seconds before unloading and carefully dis-
carding the misfired powder load into water or oil.
Operation
90˚
489-40
489-41
48
9
30
489-
WATER
489-33