Filter
Top Products
17
101437
Troubleshooting Guide (cont.)
PROBLEM
Tool does not completely
depress.
Tool does not fire.
Opening and closing of barrel
or pushing down of the tool,
etc. is not smooth but is rough
or binds.
REMEDY
Remove breech and check all
parts for correct fit assembly.
See data listed under
Tool
Does Not Completely Depress,
above.
Check firing pin indentation on
cartridge. Clean breech, breech
face, and firing pin.
Inspect and clean complete tool
(see
Maintenance
on page 16).
Replace worn or damaged
parts.
POSSIBLE CAUSE
Misassembled or damaged
breech and firing pin parts.
Failure of tool to depress
completely.
Dirt buildup on breech not
allowing proper penetration of
firing pin.
Lack of proper cleaning.
Parts Centrals
Contact authorized dealers of this product. If they can’t supply original replacement part(s),
either contact your nearest Parts Central (see below) or call DESA International’s Parts
Department at 1-800-972-7879.
When calling DESA International, have ready
• model number of your tool • replacement part number
RAILWAY DISTRIBUTORS
264 Railway Avenue
Campbell, CA 95008
408-866-9266
Guy Bothelho
BALTIMORE ELECTRIC
1348 Dixwell Avenue
Hamden, CT 06574
1-800-397-7553
203-248-7553
Parts Department
ALL TOOL & FASTENER
7830 N.W. 72nd Avenue
Miami, FL 33166
305-888-6909
Parts Department
PRECISION TOOL
431 Commerce Park Drive
Suite 106
Marietta, GA 30060
404-421-0688
Bob Young
PORTABLE HEATER PARTS
342 No. County Road 400 East
Valparaiso, IN 46383
219-462-7441
1-800-362-6951
F B D
601 Hope Street
Bowling Green, KY 42101
502-796-8406
1-800-654-8534
MASTER SERVICE CENTER
1184 Wilson NW
Grand Rapids, MI 49504
US 1-800-446-1446
616-791-4760
Mike Fowler
MANZO ASSOCIATES
1645 Bustleton Pike
Feasterville, PA 19053
215-364-0480
Parts Department
21st CENTURY
RD 2, Box 165
Perkasie, PA 18944
215-795-0400
1-800-325-4828
Parts Department
BLUEBONNET TOOL
10490 Shady Trail
Suite 104
Dallas, TX 75220
214-358-2363
Ken Perry
CLARK SUPPLY
9435 Summerbell
Houston, TX 77074
713-771-0404
Parts Department