Filter
Top Products
7
101437
CAST IRON GLASS
TILE
BRICK
482-33
Safety Precautions
3. NEVER make fastenings in spalled or cracked areas.
2. NEVER attempt to drive power fasteners into very hard or brittle materials including, but not
limited to cast iron, glass, tile, stone, brick, or hardened steel. Materials of this type tend to
shatter and create hazard from flying particles.
4. NEVER drive power fasteners into thin or easily penetrated materials unless it is backed by
concrete or steel. When in doubt, such as when base material is concealed, conduct a Center
Punch Test (See page 6). Check continually to avoid fastening into unsuitable material,
especially in older buildings.
5. DO NOT fasten through or within 1/2" of predrilled or pre-punched holes.
G 018
G 018
G 018
G 018
G 018