Filter
Top Products
Safety Instructions
This manual contains information that is
very important to know and understand.
This information is provided for SAFETY
and to PREVENT EQUIPMENT PROB-
LEMS. To help recognize this informa-
tion, observe the following symbols.
Safety Signal Words
Danger indicates
an imminently haz-
ardous situation which, if not avoided,
WILL result in death or serious injury.
Warning indicates
a potentially haz-
ardous situation which, if not avoided,
COULD result in death or serious injury.
Caution indicates
a potentially haz-
ardous situation which, if not avoided,
MAY result in minor or moderate injury.
Notice indicates
important informa-
tion, that if not followed, may cause dam-
age to equipment.
NOTICE:
!
CAUTION:
!
WARNING:
!
DANGER:
Fr 22 3
Air compressors are utilized in a variety
of air system applications. Because air
compressors and other components
(material pump, spray gun, filters,
lubrications, hoses, etc.) used make up a
high pressure pumping system, the
following safety precautions should be
observed at all times. Only persons well
acquainted with these rules of safe
operation should be allowed to use the
air compressor.
1. Read instruction manuals for each
component carefully, before
attempting to assemble, disassemble
or operate your particular system.
2. Wear safety glasses (meeting ANSI
Z87.1 or in Canada CSA Z94.3-99)
and use hearing protection when
operating the pump or unit. Everyday
glasses are not safety glasses.
3. Do not exceed pressure rating of any
component in system.
4. Protect material lines and air lines
from damage or puncture. Keep hose
and power cable away from sharp
objects, chemical spills, oil, solvents,
and wet floors.
5. Never point a spray gun at oneself or
any other person. Accidental
discharge may result in serious injury.
6. Check hoses for weak or worn
condition, before each use, making
certain all connections are secure; do
not use if deficiency is found. Notify
an authorized service facility for
examination or repair.
7. Release all pressures within system
slowly; dust and debris may be harmful.
Before Using the Air Compressor
All electrical work should be
done by a qualified (licensed or
certified) electrician. On a prop-
erly wired circuit, the black
wires supply a voltage poten-
tial even when the unit is off.
!
WARNING:
Disconnect power and depres-
surize system before servicing
air compressor! (Turn pressure
regulator knob fully clockwise
after shutting off compressor.)
!
WARNING:
Pièces de rechange
Pour les pièces de rechange, appeler le 1-800-4-RIDGID
S’il vous plaît fournir l’information suivante:
-Numéro du modèle
-Numéro de série (si applicable)
-Description de la pièce et son numéro sur la liste de pièces
No de No de Numéro
clé catalogue de pièce Description Qte
1 -- -- Corps du moteur 1
2 -- -- Bouchon 1
3 -- -- Ventilateur 1
4 † † Boulon (M4 X 21) 2
5 † † Rondelle (M4) 2
6 † † Écrou (M4) 2
7 † † Vis (M5 x 6) 3
8 -- -- Garde-ventilateur 1
9 † † Vis (M8 x 20) 4
10 † † Rondelle 4
11 -- -- Tampon isolateur 4
12 † † Écrou (M8) 4
13 † † Vis hexagonale creuse (M6 x 80) 4
14 † † Rondelle (M6) 4
15 28343 FP250018AV Tête du cylindre 1
16 28348 FP250019AV Valve de démarrage à froid 1
17 ▲▲ Joint d’étanchéité de couvercle de
cylindre 1
18 ▲▲ Goupille de valve 2
19 ▲▲ Plaque de contact 1
20 ▲▲ Plaque de cylindre 1
21 ▲▲ Plaque de valve 1
22 ▲ ■ ● ▲ ■ ● Joint d’étanchéité de cylindre 1
23 ■■ Cylindre 1
24 ●● Support d’anneau de piston 1
25 ●● Anneau de piston 1
26 ●● Vis (M4 x 8) 1
27 ●● Rondelle (M4) 1
28 ●● Valve 1
29 ●● Tige de piston 1
30 ●● Rondelle (M4) 1
31 ●● Vis (M4 x 20) 1
32 ◆◆ Excentrique 1
33 ◆◆ Boulon 1
34 ◆◆ Roulement à billes 1
35 ▼▼ Garniture 1
36 ▼▼ Couvercle de protection 1
37 † † Vis (M5 x 32) 3
Suite à la page suivante