Filter
Top Products
Fr 21
Pièces de rechange
8. Follow all local electrical and safety
codes, as well as the National
Electrical Code (NEC) and the
Occupational Safety and Health Act
(OSHA).
9. Wiring and fuses should follow
electrical codes, current capacity, and
be properly grounded.
10. Electric motors must be securely and
adequately grounded. See grounding
instructions and extension cord
information in this manual.
11. Always disconnect power source
before working on or near a motor, or
its connected load. If power
disconnect point is out-of-sight, lock it
in the open position and tag to
prevent unexpected application of
power.
12. Guard all moving parts; keep visitors
away. Never allow children in work
area.
13. Use only a properly grounded outlet
that will accept a three pronged plug,
and wear shoes to prevent shock
hazards.
14. Be careful when touching exterior of
operating motor; it may be hot enough
to cause injury.
15. Protect power cable from coming in
contact with sharp objects.
16. Clean electrical or electronic
equipment with an approved cleaning
agent, such as dry, nonflammable
cleaning solvent.
17. To avoid spontaneous combustion,
discard waste rags into approved
metal waste cans.
18. Never store flammable liquids or
gases in vicinity of compressor.
19. When spraying with solvent of toxic
chemicals, follow instructions
provided by the chemical
manufacturer.
20. Spray in a well ventilated area, to
keep fumes from collecting and
causing health and fire hazards.
21. Do not spray in vicinity of open flames
or other places where a spark can
cause ignition. Do not smoke when
spraying paint, insecticides, or other
flammable substances.
22. Use a respirator when spraying.
23. NEVER reset safety valve or pressure
switch. Keep safety valve free from
paint and other accumulations. This
provides safety against over pressure.
24. Do regular maintenance; keep all
nuts, bolts, and screws tight, to be
sure equipment is in safe working
condition.
25. Keep cleaning rags and other
flammable waste materials in a tightly
closed metal container and dispose of
later in the proper fashion.
26. Drain tanks of moisture after each
day’s use. If unit will not be used for a
while, it is best to leave drain cock
open until such time as it is to be
used. This will allow moisture to
completely drain out and help prevent
corrosion of inside of tank.
27. Inspect tank yearly for pin holes or
any other imperfections that could
cause it to become unsafe. NEVER
weld or drill holes in air tank.
28. This product is not intended for
installation or use in a commercial
garage or the like.
Safety Instructions (continued)
4
1
12
23
34
2
13
24
35
3
14
25
36
4
15
26
37
5
16
27
38
6
17
28
39
7
18
29
40
8
19
30
41
9
20
31
10
21
32
11
22
33