Filter
Top Products
3
Safety Instructions
This manual contains information that is very important
to know and understand. This information is provided
for SAFETY and to PREVENT EQUIPMENT PROBLEMS.
To help recognize this information, observe the following
symbols.
Safety Signal Words
Danger indicates an imminently
!
DANGER:
hazardous situation which, if not
avoided, will result in death or serious injury.
Warning indicates a potentially
!
WARNING:
hazardous situation which, if not
avoided, could result in death or serious injury.
Caution indicates a potentially
!
CAUTION:
hazardous situation which, if not
avoided, may result in minor or moderate injury.
Notice indicates important
NOTICE:
information, that if not followed, may
cause damage to equipment.
Before Using the Air Compressor
Air compressors are utilized in a variety of air system
applications. Because air compressors and other
components (material pump, spray gun, filters,
lubrications, hoses, etc.) used make up a high pressure
pumping system, the following safety precautions
should be observed at all times. Only persons well
acquainted with these rules of safe operation should be
allowed to use the air compressor.
1. Read instruction manuals for each component
carefully, before attempting to assemble,
disassemble or operate your particular system.
2. Wear safety glasses (meeting ANSI Z87.1 or in
Canada CSA Z94.3-99) and use hearing protection
when operating the pump or unit. Everyday glasses
are not safety glasses.
3. Do not exceed pressure rating of any component in
system.
4. Protect material lines and air lines from damage or
puncture. Keep hose and power cable away from
sharp objects, chemical spills, oil, solvents, and wet
floors.
5. Never point a spray gun at oneself or any other
person. Accidental discharge may result in serious
injury.
6. Check hoses for weak or worn condition, before
each use, making certain all connections are secure;
do not use if fault is found. Contact an authorized
service facility for examination or repair.
7. Release all pressures within system slowly; dust and
debris may be harmful.
8. Follow all local electrical and safety codes, as
well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
9. Wiring and fuses should follow electrical codes,
current capacity, and be properly grounded.
10. Electric motors must be securely and adequately
grounded. See grounding instructions and extension
cord information in this manual.
11. Always disconnect power source before working
on or near a motor, or its connected load. If power
disconnect point is out-of-sight, lock it in the open
position and tag to prevent unexpected application
of power.
12. Guard all moving parts; keep visitors away. Never
allow children in work area.
!
WARNING:
All electrical work should be done by a qualified
(licensed or certified) electrician. On a properly
wired circuit, the black wires supply a voltage
potential even when the unit is off.
!
WARNING:
Disconnect power and depressurize system
before servicing air compressor! (Turn pressure
regulator knob fully clockwise after shutting off
compressor.)
CALIFORNIA PROPOSITION 65
!
WARNING:
This product or its power cord may contain
chemicals, including lead, known to the State
of California to cause cancer and birth defects
or other reproductive harm. Wash hands after
handling.
!
WARNING:
You can create dust when you cut, sand,
drill or grind materials such as wood,
paint, metal, concrete, cement, or other
masonry. This dust often contains chemicals
known to cause cancer, birth defects, or other
reproductive harm. Wear protective gear.