Filter
Top Products
4
13. Use only a properly grounded outlet that will accept
a three pronged plug, and wear shoes to prevent
shock hazards.
14. Be careful when touching exterior of operating
motor; it may be hot enough to cause injury.
15. Protect power cable from coming in contact with
sharp objects.
16. Clean electrical or electronic equipment with an
approved cleaning agent, such as dry, nonflammable
cleaning solvent.
17. To avoid spontaneous combustion, discard waste
rags into approved metal waste cans.
18. Never store flammable liquids or gases in vicinity of
compressor.
19. When spraying with solvent or toxic chemicals,
follow instructions provided by the chemical
manufacturer.
20. Spray in a well ventilated area, to keep fumes from
collecting and causing health and fire hazards.
21. Do not spray in vicinity of open flames or other
places where a spark can cause ignition. Do not
smoke when spraying paint, insecticides, or other
flammable substances.
22. Use a respirator when spraying.
23. NEVER tamper with safety valve or pressure
switch. Keep safety valve free from paint and other
accumulations. This provides safety against over
pressure.
24. Do regular maintenance; keep all nuts, bolts, and
screws tight, to be sure equipment is in safe working
condition.
25. Keep cleaning rags and other flammable waste
materials in a tightly closed metal container and
dispose of later in the proper fashion.
26. Drain tanks of moisture after each day’s use. If unit
will not be used for a while, it is best to leave drain
cock open until such time as it is to be used. This
will allow moisture to completely drain out and help
prevent corrosion of inside of tanks.
27. Inspect tanks yearly for pin holes or any other
imperfections that could cause it to become unsafe.
NEVER weld or drill holes in air tanks.
28. This product is not intended for installation or use in
a commercial garage or the like.
Safety Instructions (Continued)
!
WARNING:
Do not spray flammable materials in
vicinity of open flame or near ignition
sources including the compressor unit.
!
DANGER:
Breathable Air Warning
This compressor / pump is not equipped and should not be used “as is” to supply breathing quality air. For
any application of air for human consumption, the air compressor/pump will need to be fitted with suitable
in-line safety and alarm equipment. This additional equipment is necessary to properly filter and purify the
air to meet minimal specifications for Grade D breathing as described in Compressed Gas Association
Commodity Specification G 7.1 - 1966, OSHA 29 CFR 1910. 134, and/or Canadian Standards Associations
(CSA).
DISCLAIMER OF WARRANTIES
In the event the compressor is used for the purpose of breathing air application and proper in-line safety
and alarm equipment is not simultaneously used, existing warranties shall be voided, and Campbell
Hausfeld disclaims any liability whatsoever for any loss, personal injury or damage.
Spraying Precautions
1. Do not smoke when spraying paint, insecticides, or
other flammable substances.
2. Use a face mask / respirator when
spraying and spray in a well ventilated
area to prevent health and fire hazards.
3. Do not direct paint or other sprayed material at the
compressor. Locate compressor as far away from
the spraying area as possible to minimize overspray
accumulation on the compressor.
4. When spraying or cleaning with solvents or toxic
chemicals, follow the instructions provided by the
chemical manufacturer.