Filter
Top Products
Page 5
INTRODUCTION
This kit gives you the capability of mounting a router on
the accessory table of your saw. A router mounted on
the accessory table will provide expanded capabilities
for making rabbets, grooves, chamfers, dovetails, and
mortise and tenon joints.
The additional versatility gained from use of this kit will
turn your table saw into a remarkable wood-shaping
center.
NOTE:
This router kit has been specifically designed for use
with Ryobi Routers Only. The hole pattern on the
mounting plate has not been drilled to accommodate
other routers.
WARNING:
Attempting to assemble the Router Mounting kit or
to use in any way without obtaining any missing
parts and installing them correctly, could result in
an accident resulting in possible serious injury.
WARNING:
Unplug the power supply cord of your saw from the
electrical outlet before you begin mounting this kit. It
should remain disconnected until the mounting
operation is complete, all attachments are installed
properly, and they have been checked to make sure
they are secure. Failure to unplug your saw could
result in accidental starting causing possible serious
personal injury.
UNPACKING
WARNING:
Do not attempt to operate this tool until you have read
thoroughly and understand completely all instructions,
safety rules, etc. contained in this manual. Failure to
comply can result in accidents involving fire, electric
shock, or serious personal injury. Save this operator's
manual and review frequently for continuing safe operation
and instructing others who may use this tool.
TOOLS NEEDED
INFORMATION
Remove the loose parts from the box. Make sure that all
items listed in the loose parts list and shown in Figure 1 on
page 6 are included.
■ Remove the loose parts from the box. Make sure that all
items listed in the loose parts list are included.
■ Inspect all parts carefully to make sure no breakage or
damage occurred during shipping.
■ If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
WARNING:
If any parts are missing do not assemble the kit until the
missing parts are replaced. Failure to do so could result
in serious personal injury.
Tools needed for assembly of this kit are a phillips
screwdriver, two flat head screwdrivers, and an
adjustable wrench.
NOTE: The adjustable wrench will be used to tighten
the threaded post into one of the special 5/16 in. T-nuts
provided.