Ryobi BS1001SV Saw User Manual


 
Page 15
ASSEMBLY
TO SQUARE THE SAW TABLE TO THE BLADE
See Figure 11.
n Turn the blade guide lock knob counterclockwise to
unlock the blade guide assembly. Turning the blade guide
knob clockwise, raise the blade guide assembly as far as
it will go. Turn the lock knob clockwise to retighten.
n Place a small combination square on the saw table beside
the blade.
n Loosen the bevel lock knob and rotate the bevel
adjustment knob to tilt the saw table up or down to align
table 90° to blade (0° position). Retighten the bevel lock
knob.
n Using a hex key, adjust the zero stop set screw until the
set screw just touches the saw housing.
n Check squareness of the saw table to the blade. Make
readjustments if necessary.
n Loosen screw on scale indicator with a phillips screwdriver
and align scale indicator to zero.
n Tighten all screws securely.
TO INSTALL DUST BAG
See Figure 12.
This tool comes with a dust bag for dustless cutting. To
install the dust bag:
n Position the nozzle of the dust bag in line with the dust
exhaust port on the back of the band saw.
n Push the dust bag nozzle firmly into the exhaust port.
NOTE: For more efficient operation, empty dust bag when
no more than half full. Turn bag inside-out and shake
vigorously to remove dust. This will permit better air flow
through the bag.
BLADE
GUARD
SMALL
COMBINATION
SQUARE
SAW
BLADE
ZERO STOP
SET SCREW
DUST
BAG
DUST
EXHAUST
PORT
Fig. 11
Fig. 12
Fig. 10
WING
NUT
LOCK KNOB
WASHER
TABLE
ALIGNING
BOLT
BLADE GUIDE
KNOB