Filter
Top Products
10
11
OPERATION
ROUGH SURFACE ADAPTOR
See Figure 6.
Using the rough-surface adaptor, you can use
the laser level’s AIRgrip
™
feature to positon the
unit on many non-smooth surfaces, including
brick and painted cinderblock.
NOTE: The AIRgrip
™
feature cannot be used
with stucco or unpainted cinderblock.
n Position the rough-surface adaptor on the
surface where you want to secure the laser
level.
NOTE: The dotted lines on the adaptor
should be visible.
n Place the laser level against the adaptor
on the dotted lines, and push in slightly to
engage the seal.
n Continue to hold the laser level against the
surface while pressing the on/off switch.
n Release the laser level when you hear a
change in motor sound.
USING MULTI-FUNCTION BASE
See Figure 7.
Velcro
®
strap, push pin, and tripod mounting
methods are available only when the multi-
function base is installed. To install the base:
n While holding the laser level with the power
switch facing you, align the raised ridge on
the base with the groove on the level.
n Slide the laser level and base completely
together.
NOTE: If the base is seated correctly, the
vacuum will not operate when the power
is turned on.
VELCRO
®
STRAP: The strap can be used
to attach the laser level to irregularly shaped
Fig. 6