Filter
Top Products
17
Fig. 21
2
3
1
45
0
15
45
50
30
2
3
1
45
0
15
45
50
30
0
4
1
45
1
2
3
OPERATION
BEVEL CUTTING
See Figures 19 - 21.
Align the line of cut with the inner blade guide notch on
the base when making 45° bevel cuts.
Make a trial cut in scrap material along a guideline to
determine how much you should offset the guideline on
the cutting material.
Adjust the angle of the cut to any desired setting between
zero and 51.5°. Refer to “Adjusting the Bevel Setting”
next.
NOTE: When making bevel cuts, you may need to re-adjust
the laser. (See “Adjusting the Laser.”)
ADJUSTING THE BEVEL SETTING
See Figure 20.
Loosen the bevel adjustment knob.
Raise the motor housing end of the saw until you reach
the desired angle setting on the bevel scale.
Tighten the bevel adjustment knob securely.
WARNING:
Attempting a bevel cut without having the bevel ad-
justment knob securely tightened can result in serious
injury.
MAKING A BEVEL CUT
See Figure 21.
Hold the saw firmly with both hands as shown.
Rest the front edge of the base on the workpiece.
Start the saw and let the blade reach full speed.
Guide the saw into the workpiece and make the cut.
Release the trigger and allow the blade to come to a
complete stop.
Lift the saw from the workpiece.
Fig. 19
Fig. 20
BLADE GUIDE NOTCH
BEVEL
ADJUSTMENT
KNOB
MOTOR
HOUSING
BEVEL
SCALE
BEVEL
ADJUSTMENT KNOB
BLADE
GUIDE NOTCH
LOWER
BLADE GUARD
GUIDELINE
BEVEL SCALE