Filter
Top Products
20
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
WARNING:
Always wear safety goggles or safety glasses with side
shields during power product operation or when blowing
dust. If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
REPLACING LASER GUIDE BATTERIES
See Figure 25.
Remove the battery pack from the saw.
Make sure the laser is turned off.
Remove the laser cover by lifting it off its base.
Remove both AAA batteries.
Install the two AAA batteries, aligning the positives (+)
with positives (+) and the negatives (-) with negatives (-)
as shown on the inside base of the laser.
Replace the laser cover.
Turn on the laser.
CAUTION:
Use of controls or adjustments or performance other than
those specified herein may result in hazardous radiation
exposure.
Fig. 25