Filter
Top Products
Page 8
WARNING:
Your router or router table should never be connected to
power supply when you are assembling parts, making
adjustments, installing or removing cutters, cleaning, or
when not in use. Disconnecting your router and router table
will prevent accidental starting that could cause serious
personal injury.
LEG ASSEMBLY
Place router table upside down on a flat, level surface,
so that the front edge is closest to you. Position legs as
shown in Figure 3. With the router table upside down,
the leg with the rectangular cutout should be in the front
left corner of the table.
Align the four holes in each leg with the four
corresponding threaded holes in each corner of the table.
Use the hex wrench provided to secure each leg with
four 1/4-20 x 1/2 in. socket head screws and four lock
washers.
LOWER GUARD ASSEMBLY
Locate the two gray lower guards. Position them
around the throat of the table so that the three holes
of each guard line up with the three threaded holes in
the table. Use the hex wrench provided to secure each
lower guard with three 1/4-20 x 1/2 in. socket head
screws.
See Figure 4.
SWITCH BOX ASSEMBLY
Hold the switch box so that the words ON and OFF on the
toggle switch are upside down. Carefully insert switch box
through the cutout in the left front leg as shown in Figure 5.
Align the two small holes in the mounting tabs with the
two small holes in the leg. Using a #2 Phillips screw-
driver, securely tighten each #6 thread cutting screw.
ATTACH ROUTER TO TABLE
Carefully turn table right side up and check to make sure
it rests on all four legs and does not rock. Locate the
three large holes surrounding the throat of the table and
the three 5/16-18 x 1 in. phillips head machine screws.
Remove the subbase screws and subbase from your router.
Hold the router upside down so that the Ryobi label is
facing the front of the table. Align the holes in the table
with the holes in the router. Holding the router with one
hand, use the other hand to securely tighten each of the
three screws with a phillips screwdriver.
See Figure 6.
FENCE ASSEMBLY
Turn the fence assembly over and locate the four small
circular tabs. Position the fence on the router table so that
the two tabs on the left engage the left channel of the table
and the two tabs on the right engage the right channel.
ASSEMBLY
Fig. 3
Fig. 5
Fig. 6
Fig. 4
Locate the two square nuts and two fence lock knobs.
Position a square nut inside the channel located underneath
the table. Insert the lock knob through the hole in the fence
assembly and screw it into the square nut below.
See Figures
7a and 7b.
Repeat for the other side.