Ryobi TS1302 Saw User Manual


 
Page 15
0
2
2
.5
30
15
3
1
.
6
2
2.5
30
1
5
3
1
.6
45
5
45
Fig. 19
Fig. 20
SOCKET
HEAD SCREW(S)
SOCKET
HEAD SCREW(S)
SQUARING THE MITER TABLE TO THE FENCE
See Figures 17 - 20.
Unplug your saw.
WARNING:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
Push down on the saw arm and pull out the lock pin to
release the saw arm.
See Figure 3.
Raise saw arm to its full raised position.
Loosen the miter lock handle approximately one-half
turn.
Depress the miter lock plate and rotate the miter table
until the pointer on the control arm is positioned in the
positive stop at 0°.
Release the miter lock plate and securely tighten the
miter lock handle.
Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Place the other leg
of the square beside the blade slot in the miter table.
The edge of the square and the blade slot in the miter
table should be parallel as shown in figure 17.
If the edge of the framing square and the blade slot in
the miter table are not parallel as shown in figures 18
and 19, adjustments are needed.
Using the wrench provided, loosen the socket head
screws securing the fence.
See Figure 20.
Adjust the
fence left or right until the framing square and blade slot
are parallel.
Retighten the screws securely and recheck the fence-
to-table alignment.
FENCE
MITER TABLE
BLADE SLOTFRAMING
SQUARE
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
ADJUSTMENTS
Fig. 18
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER TABLE
BLADE SLOT
FENCE
FRAMING
SQUARE
FENCE
MITER
LOCK HANDLE
BLADE SLOT
MITER TABLE
MITER
LOCK PLATE
FRAMING
SQUARE
FENCE
VIEW OF MITER
TABLE SQUARE WITH FENCE
Fig. 17