Ryobi TS1302 Saw User Manual


 
Page 8
KNOW YOUR MITER SAW
See Figure 2.
Before attempting to use your saw, familiarize yourself with
all operating features and safety requirements.
WARNING:
Do not allow familiarity with your miter saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
14 AMP MOTOR
Your saw has a powerful 14 amp motor with sufficient
power to handle tough cutting jobs. It is made with all ball
bearings.
10 in. (254 mm) BLADE
A 10 in. (254 mm) saw blade is included with your miter
saw. It is fine for most wood cutting operations, but for fine
joinery cuts or cutting plastic, use one of the accessory
blades available from your nearest dealer.
FEATURES
CUTTING CAPACITIES
When the miter angle (miter table) is set at 0°:
Maximum dimensional lumber sizes: 4 x 4
2 x 6
When the miter angle (miter table) is set at 45°:
Maximum dimensional lumber size: 2 x 4
BLADE WRENCH / STORAGE AREA
See Figure 2.
A blade wrench is packed with your saw. One end of the
wrench is a phillips screwdriver and the other end is a 1/4 in.
(6.4 mm) hex key. Use the hex key end when installing or
removing blade and the phillips end when removing or
loosening screws. A storage area for the blade wrench is
located behind the fence.
CARRYING HANDLE
See Figure 3.
For convenience when carrying or transporting your miter
saw from one place to another, a carrying handle has been
provided on top of the saw arm as shown in figure 3. To
transport, turn off and unplug your saw, then lower the saw
arm and lock it in the down position. Lock saw arm by
depressing the lock pin. Tighten the miter lock handle.
Remove the saw from the workbench or workstand. It is now
ready to transport.
45
30
15
30
45
31
.62
22.5
31.62
22.5
LOWER
BLADE GUARD
DUST BAG
UPPER
BLADE GUARD
SAW ARM
FENCE
SWITCH
TRIGGER
NO HANDS
ZONE LABEL
MITER TABLE
BASE
CONTROL ARM
"NO HANDS ZONE"
BOUNDARY LINE
POSITIVE STOP (S)
BLADE
STOP
BLOCK
TABLE
EXTENSION
MITER TABLE
MITER SCALE
MITER
LOCK HANDLE
MITER
LOCK PLATE
TABLE
EXTENSION
LOCK
PIN
CARRYING HANDLE
45
3
0
1
5
15
BLADE
WRENCH
WRENCH
STORAGE
AREA
Fig. 2