Filter
Top Products
© 2008 • All rights reserved. 19
HDR44 4x4 High Defi nition Video Router
IR Connections
Front Panel IR Emitter Connection
Insert the 3.5mm plug of an IR emitter into the designated IR Out port of the R44WP and place
the emitter on the IR receive window of an in-room video source or display.
P
R
P
B
Y
SPDIFSPDIF
IR OUTOUT
IR ININ
L
R
R44WP
HD Video Display
IR Emitter
Figure 3-15: R44WP Front Panel IR Emitter Connection
Rear Panel IR Emitter Connection
Run a Cat-5 wire from the R44WP to the location of an in-room video source or AV Receiver.
Next, cut off the 3.5mm plug of an IR emitter and strip back the wire jacket to expose the wires.
Then, twist the bare ends of the IR emitter wires and splice them onto the appropriate conduc-
tors of the Cat-5 wire as shown in Figure 3-16
. Finally, connect the correct Cat-5 conductors to
the screw terminals of the R44WP.
IR OUT
GND
ATON AIE2
IR Emitter
to Source
R44WP
SPLICE
IR (White Stripe)
GND (Black)
GND (Brown)
IR (Blue/White)
Cat-5 Cable
Figure 3-16: R44WP Rear IR Output