Filter
Top Products
20 ©2008 • All rights reserved.
HDR44 4x4 High Defi nition Video Router
Front Panel IR Receiver Connection
Connect an ATON IR Receiver to R44WP front panel IR Input connector as shown in Figure 3-17.
P
R
P
B
Y
SPDIF
SPDIF
IR
OUT
OUT
IR IN
L
R
R44WP
HD Video Display
IR Receiver
3.5mm mono
connector
Figure 3-17: R44WP Front Panel IR IN Connection
+12VDC
IR IN
AIR1 IR Receiver
R44WP
GND
SPLICE
IR (White)
GND (Black)
GND (Brown)
IR (Blue/White)
Cat-5 Cable
+12V (Red)
+12V (White/Green)
Figure 3-18: R44WP Rear Panel IR IN Connection
Run a Cat-5 wire from the R44WP to the IR Receiver location. Next, cut off the 3.5mm plug of
the IR Receiver and strip back the wire jacket to expose the conductor wires. Then, strip the
ends of the conductors and twist the bare ends of the IR Receiver wires to the appropriate con-
ductors of the Cat-5 wire as shown in Figure 3-18. Finally, connect the correct Cat-5 conductors
to the screw terminals of the R44WP.