Filter
Top Products
2
257-800
PREPARING TO CHARGE
C
1. Make sure you have a 6 or 12 volt lead-acid battery. Check
car owner manual to make sure.
2. Clean battery terminals. Take care to keep corrosion from
coming in contact with your eyes.
3. If required, add distilled water in each cell until battery acid
reaches levels specified by battery manufacturer. This helps
purge excessive gas from cells. Do not overfill. For a bat-
tery without cell caps, carefully follow manufacturer's re-
charging instructions.
4. Study all battery manufacturer's specific precautions, such
as removing or not removing cell caps while charging, and
recommended rates of charge.
5. Be sure area around battery is well ventilated while battery
is being charged. Gas can be forcefully blown away by
using a piece of cardboard or other non-metallic material
as a fan.
6. If necessary to remove battery from vehicle to charge, al-
ways remove grounded terminal from battery first. Make
sure all accessories in the vehicle are off, so as not to
cause an arc.
7. A marine (boat) battery must be removed and charged on
shore. To charge it on board requires equipment specially
designed for marine use.
8. Select charge rate suitable for the battery being charged -
(2 or 15 Amps)
GROUNDING AND AC POWER CORD CONNECTION INSTRUC-
TIONS - Charger should be grounded to reduce risk of electric
shock. Charger is equipped with an electric cord having an
equipment-grounding conductor and a grounding plug. The plug
must be plugged into an outlet that is properly installed and
grounded in accordance with local codes and ordinances.
DANGER - Never alter AC cord or plug provided - if it will not fit
outlet, have proper outlet installed by a qualified electrician.
Improper connection can result in a risk of electric shock.
This battery charger is for use on a nominal 120-volt circuit, and
has a grounding plug that looks like the plug illustrated in sketch
A. A temporary adapter, which looks like the adapter illustrated
in sketch B, may be used to connect this plug to a two-pole
receptacle as shown in sketch B if a properly grounded outlet is
not available. The temporary adapter should be used only until
a properly grounded outlet can be installed by a qualified elec-
trician.
During operation do not place the charger or its cables on the
vehicle seat or carpeting.
When charging a battery in a boat, RV or motor home always
connect one lead of the output cable to the battery. Never con-
nect to a remote receptacle or other means for the purpose of
remotely charging the battery. The wires may be inadequate for
handling the charge current of this charger and may over heat.
Often these wires are bundled in with other wires which could
be damaged and lead to a direct short across the battery and
charger. If this occurs a fire can result, equipment and appli-
ances operated from the battery may also be damaged.
METAL SCREW
GROUNDING METHODS
DANGER - Before using adapter as illustrated, be certain that
center screw of outlet plate is grounded. The green-colored
rigid ear or lug extending from adapter must be connected to a
properly grounded outlet - make certain it is grounded. If nec-
essary, replace original outlet cover plate screw with a longer
screw that will secure adapter ear or lug to outlet cover plate
and make ground connection to grounded outlet.
(Adapter plug cannot be used in Canada)